Engine Peak Performance, Suspension Mastery, Transmission Restoration
Axiview delivers specialist automotive repair across three focused service divisions. Whether your engine needs precision tuning, your chassis demands alignment and suspension work, or your transmission requires expert rebuilding, our technicians diagnose and resolve the root cause—not just symptoms.
Torque & Tune Workshop — Engine Performance Tuning at Axiview
Is your engine performing at its actual potential, or are you leaving horsepower on the table? Torque & Tune Workshop extracts hidden power from your engine through strategic calibration, fuel mapping adjustments, and load optimization—proven methods that increase both output and drivability without compromise.
- Dyno-Verified Power Gains — Every tune exits our workshop with documented horsepower and torque numbers. You see the before-and-after results on our dyno sheet.
- Engine-Specific Calibration Logic — A tune that works for one engine variant may create drivability issues in another. We map your exact vehicle specifications.
- Reliability Monitoring Built In — Aggressive tuning without safeguards leads to premature wear. Our calibrations include knock detection thresholds and cylinder monitoring.
- Fuel Mapping Adjustments — Optimised air-fuel ratios for maximum efficiency and output across all load ranges.
Chassis Care Masters — Professional Suspension & Steering Service in Malaysia
Your chassis absorbs punishment every time you hit a pothole, brake hard, or navigate rough urban streets. Poor suspension geometry and misaligned steering don't just affect comfort—they accelerate tire wear, reduce braking efficiency, and compromise your safety in emergency situations. Chassis Care Masters restores precise handling geometry.
- Laser-Precision Alignment Technology — We don't estimate angles—we measure them. Our 3D alignment system captures wheel geometry to 0.1mm tolerance.
- Suspension Rebuild Without Guesswork — Worn struts, damaged bushings, and fatigued springs don't always announce themselves with noise. We perform physical component inspection.
- Steering Response Restoration — Heavy steering, delayed response, or a wandering feel indicates tie-rod wear, ball joint play, or rack-and-pinion issues we resolve at the source.
- Brake Efficiency Assessment — Suspension geometry directly impacts braking performance; we verify both systems work in sync.
Pricing
| Service | Description | Rate |
|---|---|---|
| Engine Tune | Dyno-verified fuel mapping & calibration | Call for quote |
| Chassis Alignment | 3D laser wheel alignment & suspension check | Call for quote |
| Transmission Rebuild | Full pull, inspect, rebuild & dyno test | Call for quote |
Transmission Revival Centre — Axiview Auto Service Malaysia
Manual or automatic, CVT or dual-clutch—transmission faults demand precision repair, not guesswork. Axiview's Transmission Revival Centre combines diagnostic scanning with hands-on rebuild expertise to diagnose slip, lag, and noise at their source. We inspect seals, measure clearances, and replace worn components to restore full transmission function.
- Transmission Pull & Inspection Protocol — Rather than guessing based on symptoms, we remove and bench-test the gearbox. This reveals worn bearings and scored clutch packs.
- Fluid Flush & Pressure Verification — Old transmission fluid carries metal particles and sludge that accelerate wear. We drain contaminated fluid and replace filters.
- Dyno Post-Repair Testing — After rebuild, your transmission runs on our dynamometer to confirm shift points, engagement smoothness, and torque delivery.
- Seal & Clearance Inspection — Precision measurement of internal clearances ensures rebuilt components meet OEM tolerances before reassembly.