Engine Peak Performance, Suspension Mastery, Transmission Restoration

Torque & Tune Workshop — Engine Performance Tuning at Axiview

Is your engine performing at its actual potential, or are you leaving horsepower on the table? Torque & Tune Workshop extracts hidden power from your engine through strategic calibration, fuel mapping adjustments, and load optimization—proven methods that increase both output and drivability without compromise.

• Dyno-Verified Power Gains — Every tune exits our workshop with documented horsepower and torque numbers. You see the before-and-after results on our dynamometer readout.
• Engine-Specific Calibration Logic — A tune that works for one engine variant may create drivability issues in another. We map your exact vehicle specifications for precision results.
• Reliability Monitoring Built In — Aggressive tuning without safeguards leads to premature wear. Our calibrations include knock detection thresholds and cylinder protection parameters.
• Fuel Mapping Adjustments — Optimised air-fuel ratios tailored to your engine's operating range for efficiency and peak output.
• Load Optimisation Strategy — Calibrated performance under real-world load conditions, not just ideal laboratory scenarios.
• Post-Tune Drivability Assessment — Road and dyno testing to confirm the tune performs consistently across all driving conditions.

Chassis Care Masters — Professional Suspension & Steering Service in Malaysia

Your chassis absorbs punishment every time you hit a pothole, brake hard, or navigate rough urban streets. Poor suspension geometry and misaligned steering don't just affect comfort—they accelerate tire wear, reduce braking efficiency, and compromise your safety in emergency situations. Chassis Care Masters restores your vehicle's handling precision and ride integrity.

• Laser-Precision Alignment Technology — We don't estimate angles—we measure them. Our 3D alignment system captures wheel geometry to 0.1mm tolerance, detecting subtle misalignment invisible to the naked eye.
• Suspension Rebuild Without Guesswork — Worn struts, damaged bushings, and fatigued springs don't always announce themselves with noise. We perform physical component inspection on every vehicle.
• Steering Response Restoration — Heavy steering, delayed response, or a wandering feel indicates tie-rod wear, ball joint play, or rack-and-pinion issues that we diagnose and resolve directly.
• Pothole & Impact Damage Assessment — Post-impact chassis inspection to identify hidden structural and geometry shifts before they cause secondary failures.
• Tire Wear Pattern Analysis — Uneven wear patterns reveal suspension and alignment faults. We read and correct the root cause, not just replace the tire.
• Braking Geometry Verification — Suspension geometry directly affects braking efficiency. Our checks confirm your stopping power is not compromised by chassis misalignment.

Workshop Hours & Contact

Transmission Revival Centre — Axiview Auto Service Malaysia

Manual or automatic, CVT or dual-clutch—transmission faults demand precision repair, not guesswork. Axiview's Transmission Revival Centre combines diagnostic scanning with hands-on rebuild expertise to diagnose slip, lag, and noise at their source. We inspect seals, measure clearances, and replace worn components to restore factory-grade performance.

• Transmission Pull & Inspection Protocol — Rather than guessing based on symptoms, we remove and bench-test the gearbox. This reveals worn bearings, scored clutch plates, and internal damage accurately.
• Fluid Flush & Pressure Verification — Old transmission fluid carries metal particles and sludge that accelerate wear. We drain contaminated fluid, replace filters, and verify hydraulic pressure across all circuits.
• Dyno Post-Repair Testing — After rebuild, your transmission runs on our dynamometer to confirm shift points, engage smoothness, and torque delivery under load.
• Seal & Clearance Measurement — Precise measurement of internal clearances and seal integrity to prevent post-repair leaks and pressure loss.
• Diagnostic Scan & Fault Code Analysis — Electronic fault codes are cross-referenced with physical inspection findings to confirm the true source of transmission failure.
• Shift Calibration Recalibration — Automatic and CVT units receive gear shift and engagement recalibration to restore factory-correct response timing.