Engine Peak Performance, Suspension Mastery, Transmission Restoration
Axiview delivers specialist automotive repair across three focused service divisions. Whether your engine needs precision tuning, your chassis demands alignment and suspension work, or your transmission requires expert rebuilding, our technicians diagnose and resolve the root cause—not just symptoms.
Torque & Tune Workshop — Engine Performance Tuning at Axiview
Is your engine performing at its actual potential, or are you leaving horsepower on the table? Torque & Tune Workshop extracts hidden power from your engine through strategic calibration, fuel mapping adjustments, and load optimization—proven methods that increase both output and drivability without compromise.
- Dyno-Verified Power Gains — Every tune exits our workshop with documented horsepower and torque numbers. You see the before-and-after results on our dynamometer readout.
- Engine-Specific Calibration Logic — A tune that works for one engine variant may create drivability issues in another. We map your exact vehicle specifications for precision results.
- Reliability Monitoring Built In — Aggressive tuning without safeguards leads to premature wear. Our calibrations include knock detection thresholds and cylinder protection logic.
Chassis Care Masters — Professional Suspension & Steering Service in Malaysia
Your chassis absorbs punishment every time you hit a pothole, brake hard, or navigate rough urban streets. Poor suspension geometry and misaligned steering don't just affect comfort—they accelerate tire wear, reduce braking efficiency, and compromise your safety in emergency situations. Chassis Care Masters restores your vehicle's handling to factory specification and beyond.
- Laser-Precision Alignment Technology — We don't estimate angles—we measure them. Our 3D alignment system captures wheel geometry to 0.1mm tolerance, detecting even subtle deviations.
- Suspension Rebuild Without Guesswork — Worn struts, damaged bushings, and fatigued springs don't always announce themselves with noise. We perform physical component inspection to find the real issue.
- Steering Response Restoration — Heavy steering, delayed response, or a wandering feel indicates tie-rod wear, ball joint play, or rack-and-pinion issues that we identify and fix at the source.
Contact Axiview
| Detail | Information |
|---|---|
| Phone | +60 3 2145 7832 |
| contact@axiviewe.xyz | |
| Address | 114 Jalan Tun Sambanthan, Kuala Lumpur 50470, Malaysia |
| Mon–Fri | 8:00 AM – 6:00 PM |
| Saturday | 8:00 AM – 2:00 PM |
| Sunday | Closed |
Transmission Revival Centre — Axiview Auto Service Malaysia
Manual or automatic, CVT or dual-clutch—transmission faults demand precision repair, not guesswork. Axiview's Transmission Revival Centre combines diagnostic scanning with hands-on rebuild expertise to diagnose slip, lag, and noise at their source. We inspect seals, measure clearances, and replace worn internals to deliver a gearbox that performs like new.
- Transmission Pull & Inspection Protocol — Rather than guessing based on symptoms, we remove and bench-test the gearbox. This reveals worn bearings, scored clutch plates, and internal damage not visible from outside.
- Fluid Flush & Pressure Verification — Old transmission fluid carries metal particles and sludge that accelerate wear. We drain contaminated fluid, replace filters, and verify operating pressure at every stage.
- Dyno Post-Repair Testing — After rebuild, your transmission runs on our dynamometer to confirm shift points, engage smoothness, and torque delivery under load before we hand back your vehicle.